Non-contact Type Ultrasonic Liquid Level Controller

Basic Info


Model NO.:HS-ULC

Trademark:Smagall

Origin:Shaanxi,China


Non-contact Type Ultrasonic Liquid Level Controller


Introduction:

Ultrasonic Level Meter is a continuous non-contact measurement and Monitoring device. The device is mounted on the top of the tank and generates an electric signal that is Converted by the sensor to ultrasonic pulses and transmitted through air space, these pulses hits the liquid surface and reflects back to the sensor, the device receive these echoes and calculates the level in the tank. 

By detecting and calculating the reflective behavior, the level control can identify whether there is liquid at the monitored position. The liquid level control can send relay signal to succeeding devices or other equipment at the mean time, which can realize the function of simultaneous monitoring or controlling.


Features:



Parameters: 

  1. Operating Voltage: DC 24V(18~36V)   0.05A

  2. Operating temperature: -50℃~60℃ (-58 °F – 140 °F)

  3. Repeatability error: ±2mm

  4. Measurable tank wall thickness: 2-70mm

  5. Measurable tank type: Horizontal tank, spherical tank, vertical tank and so on

  6. Material: Cast aluminum

  7. Electrical interface: Different types available for different operating condition

  8. Time lag: 1 ~ 3 seconds

  9. Explosion-proof Mark: ExdmIICT6

  10. Ingress Protection: IP65

  11. Output signal: Relay output (1 unit single-pole, double-throw control contact is passive nodes)

  12. Relay capacity: DC 30V 6A / AC 250V 6A

  13. Ambient temperature: -50℃~60℃ (-58 °F – 140 °F)

  14. Operating humidity: 15% ~ 100%RH

  15. Diameter of threading hol: Φ8mm ( adaptive cable diameter Φ6~8mm )

  16. Net Weigh: 2.5kg



Operating Conditions:

Measurable Tank Material: The probe installation area on tank wall should be hard material with good conductivity such as carbon steel, stainless steel, various hard metal, fiber glass, epikote, rigid plastic, ceramics, glass, rigid rubber and other composite material. The internal and external surface of installing position should be smooth.



Pictures:





返回顶部